.40cal/10mm 9/16x24 Tpi Muzzle Brake Comp

This is a high quality, aluminum muzzle brake compensator.  It is made in the USA (Minnesota actually). Features include:

.40cal S&W and 10mm AUTO (BUT NOT GLOCK 20)

Holsters Easy!

Designed for concealed carry

threaded for 9/16"-24 tpi right handed threads (most common .40cal threads in US)

Loosen and tighten with 2 screws for easy on/easy off

COUNTER-BORED: this feature on the slide facing side lets the brake get closer to the slide to make the gap smaller!  (see picture of the side view)

width is sized to match the Glock 22, 23, 24, and 27 (0.97" wide - measure yours to see if it will match), holsters easy.  But not Glock 20.

flush with the top of the glock slide

distance (or gap) from the front of the slide depends on your particular barrel but is reduced by up to 3/16" because of the Counter-bore.

add roughly 0.79" to the length of the barrel (however far out yours sticks)

Made of 6061 Aluminum

Anodized black, hard coat type III

held on with #6-32 x 1/2" socket head cap screws

tighten set screws to 10-12 inch pounds

This reduces felt recoil for carry, competition, or duty.  Works better with higher grain/higher power loads (they have more gas to push back against the brake with).  In some cases, very light gamer loads will not cycle the action unless springs are changed out.  Narrow ports to reduce danger in deep retention from blast. Set screws are tightened with a 7/64" allen wrench. On screws this small about 10 inch pounds is all the tighter you want to get them.

Returns Accepted for this item if it's within 30 Days